mergerfs:combine_multiple_hard_drives_into_a_single_mountpoint
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| mergerfs:combine_multiple_hard_drives_into_a_single_mountpoint [2025/04/25 13:46] – peter | mergerfs:combine_multiple_hard_drives_into_a_single_mountpoint [2025/04/29 08:19] (current) – [Created the new mount points] peter | ||
|---|---|---|---|
| Line 1: | Line 1: | ||
| ====== MergerFS - Combine multiple hard drives into a single mountpoint ====== | ====== MergerFS - Combine multiple hard drives into a single mountpoint ====== | ||
| - | |||
| - | [[MergerFS: | ||
| - | |||
| - | ---- | ||
| ===== Objective ===== | ===== Objective ===== | ||
| Line 18: | Line 14: | ||
| <WRAP info> | <WRAP info> | ||
| - | **NOTE:** | + | **NOTE:** **/ |
| - | + | ||
| - | | + | |
| </ | </ | ||
| Line 35: | Line 29: | ||
| <WRAP info> | <WRAP info> | ||
| - | **NOTE:** It is preferred to use the GitHub, rather than from APT repository, as the APT one may not be the most up-to-date version. | + | **NOTE:** It is preferred to use the GitHub |
| - | <code bash> | + | * If the APT repository were to be used, install it via: <code bash> |
| sudo apt install mergerfs | sudo apt install mergerfs | ||
| </ | </ | ||
| - | |||
| - | * **/ | ||
| </ | </ | ||
| Line 66: | Line 58: | ||
| If after mounting, there are problems with the permissions, | If after mounting, there are problems with the permissions, | ||
| - | Set user_allow_other in / | + | Set **user_allow_other** in / |
| </ | </ | ||
| Line 149: | Line 141: | ||
| ---- | ---- | ||
| - | ===== Created | + | ===== Create |
| <code bash> | <code bash> | ||
| Line 183: | Line 175: | ||
| movies | movies | ||
| </ | </ | ||
| + | |||
| + | <WRAP info> | ||
| + | **NOTE: | ||
| + | </ | ||
mergerfs/combine_multiple_hard_drives_into_a_single_mountpoint.1745588764.txt.gz · Last modified: 2025/04/25 13:46 by peter